Table of Contents
Advertisement
procedure, all previously save settings on your Verizon Router will
be lost.
For additional information regarding the Restore Defaults feature,
refer to section 5.3c/ Factory Reset/Restore Options.
•
Using the tip of a ballpoint pen or pencil, press and hold the
Reset button on the back of your Verizon Router for three
seconds.
•
Access the UI and navigate to the Advanced/System page.
Select the Factory Reset option. After saving your configuration,
if desired, click the Factory Default radio button. For additional
details, refer to the 5.3c/ Factory Reset section of this guide.
Note:
If you reset or reboot your Verizon Router, you may also need
to disconnect your Verizon Router's power supply for a few minutes
(3 or more) and then reconnect the power cable. However, in order
to provide full synchronization to the coaxial network, disconnecting
and reconnecting the power may be required.
6.0e/
LaN CONNECTION FaILURE
To troubleshoot a LAN connection failure:
•
Verify your Verizon Router is properly installed, LAN connections
are correct, and that the Verizon Router and communicating
network devices are all powered on.
•
Confirm that the computer and Verizon Router are both on the
same network segment.
06 / TROUBLESHOOTING
©2022 Verizon. All Rights Reserved
174
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the CR1000B and is the answer not in the manual?
Questions and answers
Como se instala
To install the Verizon CR1000B router:
1. Align the mounting hole on the bottom of the router with the screw on the wall mount bracket.
2. Rotate and position the router as preferred.
3. Connect the Ethernet cable to the WAN port and other required cables through the hole in the mounting bracket.
4. Tighten the bracket screw to secure the router.
5. Manage and fasten the attached cables using the Velcro® strap with buckle.
6. Power on the router and access the web-based User Interface (UI) to complete setup.
Optional: Use the WPS button or UI to connect Wi-Fi devices.
This answer is automatically generated