Download Print this page

Maintenance - Mitsubishi Electric MR-18PA Series Operating Instructions Manual

Advertisement

5. Maintenance

How to Remove the Pockets
Before you begin cleaning
Unplug the electrical plug
If it is not unplugged, it will
cause an electric shock.
Wait 10 minutes or more before you
replug the electrical plug into the outlet.
If you plug it in immediately after
unplugging it, the refrigerator will not run.
Sliding Case
1 Pull the chilled tray out all the way from its lock.
2 Pull the chilled tray out directly.
Drain Pan
1 Hold the edge of right and left sides and lift it up.
2 And pull it directly to your body and let the lock
release from the cabinet.
How to clean your accessories
Wipe with a soft cloth using warm water, or remove part and wash with water.
For hard-to-remove dirt, first clean using a diluted kitchen detergent (neutral type).
Then, finish off with a soft cloth and water. If oily substances remain for some
time, the plastic may crack.
Make sure detergents are wiped off thoroughly.
If you use a chemical cloth, please be sure to follow the attached instructions.
Please observe the following:
Do not use alkaline/mild alkaline kitchen detergents, polishing powders, powder
detergents, alcohol, benzene, thinner, kerosene, acid, scrub brushes, boiling water, etc.
Plastic parts (door handles, caps, cases, etc.) can crack, and it will damage doors
and surface paint.
CAUTION
Do not apply water directly onto the refrigerator.
This may result in malfunction, power leakage or fire.
WARNING
How to Remove the Pockets
Remove the door racks as shown in the illustration
in order to proceed with cleaning.
Hold the edge of right and left sides and lift it up.
Free Pocket
Bottle Pocket
Adjustable Pocket
It can be adjusted in both
of front and rear sides
as your requirement by
lifting it up and pulling out.
Use reverse procedures to put
accessories back in place
8

Advertisement

loading

This manual is also suitable for:

Mr-18pa-ml