Page 1
Form No. 3378-949 Rev A Finishing Kit Foam Marker for Multi Pro WM Turf Sprayer Model No. 125-8121 Installation Instructions Safety WARNING Note: Determine the left and right sides of the machine CALIFORNIA from the normal operating position. Proposition 65 Warning...
Page 2
Procedure Description Qty. Foam marker (sold separately) Foam marker bracket Bolt (1/4 inches) Install the finishing kit bracket. Bolt (3/8 inches) Nut (1/4 inches) Nut (3/8 inches) Installing the Hood 1. Connect the lights. 2. Insert the top mounting tabs into the frame slots. Routing the Wiring Harness 3.
Page 3
2. Remove the screws on the steering wheel. 3. Install the switch bracket onto the steering wheel and secure the bracket with the previously removed hardware (Figure 3). g023695 Figure 4 2. Attach the foam marker (sold separately) using 4 bolts (1/4 inch) and 4 nuts (1/4 inch) (Figure 5).
Page 4
Note: If you leave the foam in the line for more than the amount of soap solution delivered to the foam nozzles. Increasing the flow results in larger, more frequent foam 2 hours, it may become watery. Before operating after drops;...