Toro 127-6818 Installation Instructions

High-Lift Blade and Baffle Kit
2013 and After TimeMaster Lawn Mower
Model No. 127-6818
Important: You will need a torque wrench to install the blades properly. If you do not have a torque wrench or are
uncomfortable performing this procedure, contact an Authorized Service Dealer.
Note: Determine the left and right sides of the machine from the normal operating position.
This product contains a chemical or chemicals known to the State of California to
1
Preparing the Machine
No Parts Required
Procedure
1. Lock the handle in the vertical position (Figure 1); refer
to Adjusting the Handle Height in the Operator's Manual.
1. Handle locked in the vertical position
© 2013—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
1
G016519
Figure 1
Register at www.Toro.com.
WARNING
CALIFORNIA
2. Tip the machine onto its side, with the dipstick down,
until the upper handle rests on the ground.
WARNING
The blades are sharp; contacting a blade could
result in serious personal injury.
• Disconnect the wire from the spark plug.
• Wear gloves when servicing the blade.
Form No. 3378-969 Rev A
Installation Instructions
Original Instructions (EN) All Rights Reserved *3378-969* A
Printed in the USA