Subsystem Commands
Subsystem commands include alI measurement functions and some general
purpose functions. Subsystem commands are distinguished by the colon
used between keywords, as in POWer:SLOPe. Each subsystem is a set
of commands that roughly corresponds to a functional block inside the
instrument.
This causes the sweep in progress to abort and reset. If the INIT:CONT is ON
it will immediately re-initiate a new sweep.
AM: STATe
AM:STATe ONlOFFlllO
AM : STATe?
This sets and queries the status of the AM modulation.
*RST setting is OFF
2-12