Sealey CP108VCRWBO Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
Maintain the Ratchet Wrench and battery in good condition. Check moving parts alignment on a regular basis.
9
Replace or repair damaged parts. Use an authorised service agent and recommended parts only. Unauthorised parts may be
9
dangerous and will invalidate the warranty.
Ensure the Ratchet Wrench is switched off before installing the battery pack.
9
Keep the Ratchet Wrench and charger clean for best and safest performance.
9
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain long hair.
9
Evaluate your working area before using the Ratchet Wrench; e.g. ceilings, floors and enclosures may contain electrical items or
9
water piping
Ensure battery pack is correctly inserted into the Ratchet Wrench handle and latched in place before attempting to switch on
9
Ratchet Wrench.
Secure loose work pieces with a clamp, vice or other adequate holding device.
9
Avoid unintentional starting.
9
Wear approved safety eye protection (standard spectacles are not adequate).
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-skid shoes.
9
Be aware that this Ratchet Wrench does not need to be plugged into the mains power.
9
Keep children and unauthorised persons away from the working area.
9
DO NOT use the Ratchet Wrench where there are flammable liquids, solids or gases, such as paint solvents, etc.
8
DO NOT allow children to operate the Ratchet Wrench.
8
DO NOT operate the Ratchet Wrench if any parts are missing as this may cause failure and/or personal injury.
8
DO NOT hold unsecured work piece in your hand.
8
DO NOT leave the Ratchet Wrench operating unattended.
8
DO NOT carry the Ratchet Wrench with your finger on the power switch. Keep chuck direction switch in the locked position.
8
DO NOT use the Ratchet Wrench for a task it is not designed to perform.
8
DO NOT operate the Ratchet Wrench when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT get the Ratchet Wrench or battery charger wet or use in damp or wet locations.
8
1. INTRODUCTION
Compact, lightweight cordless ratchet wrench allows access to tight spaces. With spindle locking that gives more control during application and
a quick stopping function. Steel ratchet head with forward and reverse control. Robust housing with soft, comfortable grip. Body only. Requires
compatible 10.8V 2Ah or 4Ah battery and mains charger, sold separately.
2. SPECIFICATION
Model No.. .................................................. CP108VCRWBO
Battery .................. 10.8V 2Ah-4Ah Lithium-ion (not included)
Consumable parts (not included)
..........................................................CP108VBP 2Ah Battery
........................................................CP108VBP4 4Ah Battery
Drive ........................................................................... 3/8"sq.
Max. torque ...................................................... 45Nm(33lb.ft)
Noise power/noise pressure ................................. 91/80dB(A)
No-load speed .........................................................0-300rpm
Replacement parts .....................CP108VMC - mains charger
Vibration/uncertainty ..................................11.64m/s²/1.5m/s²
3. OPERATION
3.1. Fit battery.
3.2. BATTERY CHARGE STATUS TEST
3.2.1. Press trigger, all LEDs lit: battery charged, one LED lit: battery needs charging.
3.3.
In order to maintain battery efficiency:
DO NOT fully discharge. After every use fully charge the battery, charge every 4 months even if tool is not used.
If a decrease of performance of the tool is noticed, charge the battery.
3.4. Fit the socket to the wrench by snapping it onto the square drive.
© Jack Sealey Limited
10.8V 3/8"SQ DRIVE CORDLESS RATCHET
WRENCH - BODY ONLY
CP108VCRWBO
MODEL NO:
Wear protective
Wear ear
gloves
protection
Original Language Version
Wear a mask
CP108VCRWBO Issue 1 02/02/21