Page 6
English introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips. com/welcome. general description (Fig. 1) A Stick unit On/off button Maximum power (MAX) button Upper stick...
Page 7
Always use the vacuum cleaner with the filter unit assembled. Electromagnetic fields (EMF) This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today.
Page 8
English Place the upper stick on the lower stick (‘click’). Note: Make sure that the recesses of the upper stick fit exactly on the projections of the lower stick. Note: You only have to do this once. Never disassemble the upper stick from the lower stick.
Page 9
English , The charging light goes on to indicate that the appliance is charging. Note: The charging light does not give any information about the battery charge level of the vacuum cleaner. When the appliance is fully charged, the charging light goes out. Note: You can leave the appliance on the charging base, even when it is fully charged.
Page 10
English If you want to leave the appliance alone for a while or if you want to remove the handheld vacuum cleaner from the stick unit during use, you can use the parking position. Push the stick towards the floor nozzle into the parking position. After use, press the on/off button to switch off the appliance. Using the handheld vacuum cleaner You can use the handheld vacuum cleaner without the stick unit to vacuum small and hard-to-reach areas, like tables, furniture, car seats etc.
English Cleaning Always remove the adapter from the wall socket before you clean the charging base. Clean the outside of the handheld vacuum cleaner, the outside of the stick unit and the outside of the charging base with a damp cloth. For information on how to empty and clean the dust compartment and how to clean the filter unit, follow the instructions in sections ‘Emptying and cleaning the dust compartment’...
Page 12
English Remove the filter unit from the dust compartment. Shake the dust compartment with your free hand to empty the contents into a dustbin. If necessary, clean the dust compartment with a damp cloth. If necessary, clean the filter unit. See section ‘Cleaning the filter unit’ below. Put the filter unit back into the dust compartment. To reattach the dust compartment, align the slot on the dust compartment with the projection on the appliance.
Page 13
English To reattach the dust compartment, align the slot on the dust compartment with the projection on the appliance. First attach the bottom of the dust compartment (1) and then push the top of the dust compartment towards the appliance (2) until it locks into place (‘click’).
Page 14
English Place the inner filter back onto the filter holder (1) and turn it anticlockwise to attach it (2). Place the outer filter back onto the filter holder (1) and turn it anticlockwise to attach it (2). Put the filter unit back into the dust compartment. Note: Make sure you insert the filter unit in the correct way. To reattach the dust compartment, align the slot on the dust compartment with the projection on the appliance. First attach the bottom of the dust compartment (1) and then push the top of the dust compartment towards the appliance (2) until it locks into place (‘click’).
Page 15
English Press the floor nozzle release button (1) to detach the stick from the floor nozzle (2). Remove the large dirt particles from the joint. Place the stick back onto the floor nozzle (‘click’). Cleaning the roller brush When the ‘brush blocked’ light starts to flash red, the roller brush is blocked. If this happens, follow the steps below to clean the roller brush. Switch off the appliance.
Page 16
English Lift the roller brush out of the floor nozzle . Remove fluff, hairs and other dirt from the roller brush and the groove. Reinserting the roller brush First insert the end of the roller brush furthest from the retainer into the nozzle, then insert the end of the roller brush closest to the retainer into the nozzle. Close the retainer (‘click’). Note: If the roller brush is not properly inserted, you cannot close the retainer. storage Put the accessories in the storage compartment of the charging base.
Page 17
English You can store the appliance (handheld vacuum cleaner placed in the stick unit) on the charging base. Replacement We advise you to replace the inner filter and the outer filter after a prolonged period of use or if you can no longer clean them properly. Replacing the inner and outer filter Remove the filter unit from the dust compartment.
Page 18
Note: Make sure you insert the filter unit in the correct way. Accessories New inner filters are available under type number 4322 004 93471 . Contact your Philips dealer. Environment Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling.
Page 19
You can also take the appliance to a Philips service centre. The staff of this centre will remove the batteries for you and will dispose of them in an environmentally safe way.
Move the handheld vacuum cleaner slightly to the left and right a few times until you hear a click. Take the appliance to your dealer or a service centre authorised by Philips for examination.
Page 21
English Problem Solution Dust escapes from the The dust compartment may be full. Empty the dust compartment. vacuum cleaner. The dust compartment may not be attached to the appliance properly. Attach the dust compartment to the appliance properly. Perhaps the filter unit is not placed in the dust compartment properly. Place the filter unit in the dust compartment properly.