Initiate Cal And Initiate Verify - Ametek CEM/Humox User Manual

Initiate Cal and Initiate Verify

The Initiate Cal menu option allows you to perform a manual calibration. The
Initiate Verify menu option allows you to perform a manual verification. Because
these menu options function almost identically, we will discuss them together. See
the introduction to this chapter for more information on the difference between a
calibration and a verification.
The Auto Calibrate/Auto Verify and Remote Calibrate/Remote Verify selections
are only available if you have installed an Auto Calibrate Card in your Series 2000
control unit and have a Remote Calibration Unit (RCU). If the Series 2000 control
unit detects that these options are not installed, it will automatically prompt you
with a manual calibration or verification operation when you select either the Initi-
ate Cal or Initiate Verify menu options.

NOTE
This section is divided into discussions on automatic, remote, and manual calibra-
tions or verifications. See the headings below to locate the type of calibration or
verification that apply to you, then follow those instructions.
2. Select Initiate Cal or Initiate Verify from the Calibrate key menu, depending
If you replaced a cell or your cell has failed a regular calibration
due to a deteriorating cell, you will need to perform a primary cali-
bration rather than a regular calibration. See the "Primary Calibra-
tion" section in the Setup Key section for help.
See the "Mechanical Installation" section in the Installation chapter
for calibration gas requirements.
|
Calibration 5-7