Installation
7
Installation
Pressure!
Risk of injury due to pressurized or improperly installed component.
▶
Before installing and removing the pressure sensor, make sure
that the system is depressurized.
▶
Check the process connection for compatibility.
▶
Observe recommended tightening torques.
▶
Insert the pressure sensor in a G¼ process connection.
▶
Tighten firmly. Recommended tightening torque:
Upper measuring range limit value
100, 250, 400 bar
Depending on lubrication, seal and pressure load!
The sensor housing can be rotated by 345° with regard
to the process connection. Do not rotate past the end
stop!
RE 30277-02-B/07.2016, HEDE 10-3X, Bosch Rexroth AG
CAUTION
in bar
600 bar
Tightening torque in Nm
25...35 Nm
30...50 Nm
21/48