Print System Data Block (Table 5-3) - Toshiba Perfecptione Installation And Maintenance Manual

PROGRAMMING PROCEDURES
SECTION 200-255-305
FEBRUARY 1992
TABLE 5-2 (continued)
Error Codes
Program Name: System Data Block (DSYS Program)
Error Code
I
Meaning
ERSYS 00
The directory number or access code conflicts with an existing
directory number, access code, or room prefix.
ERSYS 01
I
The entered DN does not exist in the system.
ERSYS 02 -entered DN is a trunk DN.
ERSYS 05
1 The station DN has not been assigned as a remote access DN.
The entered station port is not assigned, or is not a
500/25004ype port.
ERSYS 08
I
The input port has already been assigned to
another tvoe of announcement bon.
1 i
3. Print System Data Block (Table 5-3)
3.01 To use the Print System Data Block
(PSYS
Program):
l
Perform the Authorization Procedure (Level 1 or
2).
Enter: PSYS (in response to the OK prompt).
l
When the REQ prompt is received after the
program is loaded:
Enter: PRT. '
l
The System Data Block will be output in the
same format as it was input in the
DSYS Pro-
gram.
Example: REQ PRT
EXP N
NOD 2
TOR 0000
DRT NONE
TEN N
ICPl Al-T
ICP2 Al-T
etc.
l
REQ will be prompted again once the printout is
complete.
Enter: mm
q
(to exit the program).
TABLE 5-3
Procedure - Print System Data Block
Authorization Procedure must be completed. If an OK response is received, proceed as follows:
I
ITEM
1 PROMPT 1 USER ENTRY t NOTE
I
I I PSYS
OK
- DISK LOADING -
REQ PRT
- EXECUTE -
NOTES:
response possible is: PRT = Outputs System Data Block.
Ignore line entered.
Stop printing and return to REQ.
5-8