Philips 32PFS5709/12 Service Manual page 30

EN 30 4. TPM14.2E LA
4.3.4 Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.3.5 Keyboard Control unit
1. Unplug the connector from the keyboard control panel.
2. Gently push inwards the two clips at the PSU side of the
unit. Release the unit at the PSU side and turn it away from
the PSU. Now push it towards the PSU to release the
catches at the other side of the unit. Take it out from the
metal bracket.
When defective, replace the whole unit.
4.3.6 Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
4.3.7 IR/LED Panel
1. Remove the stand bracket, as described earlier.
2. Remove fixation screw that secure the deco rear cover and
take it out from the deco.
3. Unplug the connector from the IR/LED panel.
4. Gently release the double faced adhesive tape that pasted
the panel and take it out from the deco.
When defective, replace the whole unit.
4.3.8 WIFI module
1. Unplug the connector from the SSB.
2. Remove fixation screw that secure the WIFI module, gently
remove the module from the set.
When defective, replace the whole unit.
2
2
2
2
2014-Sep-26
Mechanical Instructions
2 2
2
1
1
Figure 4-31 Rear cover removal
back to
div. table
4.3.9 AmbiLight control panel
1. Unplug the connector from the AmbiLight control panel.
2. Gently release the clip that holds the panel and take it out
from the set.
When defective, replace the whole unit.
4.3.10 LCD Panel
1. Unplug all the connector cables of the boards.
2. Gently take all the speakers out.
3. Lift the subframe with SSB, PSU, panel from the LCD panel
and put it aside.
Warning:Cause the panels of 32"/42"/47" 6500 series & 40"
6400 series & 40"/48" 6600/6700 series are bolt-on panels, the
panel could not release from bezel.
When defective, replace the whole unit.
4.4 Assembly/Panel Removal ( for 42"/47"/55"
7100 series & 42"/47" 7300 series)
Instructions below apply to the 42PFK7109/12, but will be
similar for other 42"/47"/55" 7100 series 42"/47" 7300 series
models.
4.4.1 Rear Cover
Refer to Figure 4-31 for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2], [3], [4] that secure the rear cover. Refer to
Figure 4-31 for details.
2. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
2
3
4
1
1
2
2 M4 × 10
3
1
M3 × 6
2
4
Q3 × 6
2
3
M3 × 6
4
2
19610_105.eps