More Details About Troubleshootings - Hitachi GR4000 Series Quick Start Manual

The communication The LINK LED of a
with other devices network interface board
is not possible. is not lit.
The LINK LED of a
network interface board
is lit.
NOTE For details related to chassis of GR40000 and the location of LED of other components, see the chapter
"1. Component Overview" of the GR4000 Hardware Installation Guide.

5.2 More Details About Troubleshootings

For the troubleshootings for a trouble which could not be solved in the section "5.1 Troubleshootings Related to the
Operations Introduced in This Guide Book" or for the one caused by the operations other than those introduced in this guide
book, refer to the following manuals.
Table 5-2 Manuals for troubleshootings
Category
For each kind of
GR4000 Software Manual
trouble
Details about
GR4000 Software Manual
operation logs
QSGGR4K00-10 5794047-1X
Check if an interface cable is connected to GR4000 correctly.
For details about the types of cables to be used, see the chapter "3. Preparing
Interface Cables and Terminals" of the GR4000 Hardware Installation Guide.
Check if configuration information is set correctly. Check the contents shown
as the result of doing the operations introduced in the section "3.3.3 (3) Check
configuration information you input"
information, do it referring to the section "6.3 Editingof Configuration
Informatio".
Check if the line information and routing protocols related to the device
connected to GR4000 is set correctly. If not, do it referring to the manuals for
the device connected to GR4000.
Manuals to be referred
Operations - Device Management Overview
Message Log Reference
GR4000 Quick Start Guide, Revision 1 - Preliminary
.
If you want to edit configuration
45