Setup Of Gr4000 - Hitachi GR4000 Series Quick Start Manual

GR4000 Quick Start Guide, Revision 1 - Preliminary

2.1 Setup of GR4000

In this section, you can learn how to set up GR4000.
The setup of GR4000 should be done according to the following procedures.
NOTE Skip to the chapter "3. Configuration Information Setting" in case that you consigned the setup
of GR4000 to our local service staffs in your region.
Setup of GR4000-80E1
●Setup procedures
6.
Procedure
Check LED.
4.
Procedure
Attach an interface
cable.
2.
Procedure
Install a memory
card.
Procedure
Figure 2-1 Procedures for GR4000-80E1 setup
1.
Procedure
Attach a power cable.
Attach power cables to all the power supply units in GR4000-80E1.
When connecting the device to a power supply unit, use only grounded
Warning
power outlets. Failing to use grounded outlets creates a shock hazard.
Use the power cable provided with a chassis. If you use a power cable other
Warning
than this, it could cause a fire or an electric shock.
Before attaching a power cable, make sure that all the switches of GR4000 are
NOTE
turned OFF.
2.
Procedure
Install a memory card.
Insert a memory card into both the memory card slot 0 and the memory card slot 1 of a basic control unit (BCU0).
Caution While the access indicator of BCU (ACC lamp) is lit, the memory card is being accessed. DO NOT
pull out a memory card or turn off the power switch while the memory card is being accessed. If
so, you could permanently damage the memory card.
NOTE When inserting a memory card, the surface labeled with the part number "HN-F9244-66X" should
be faced up.
6
1
.
Attach a power cable.
Procedure
80E1.
3.
Procedure
Connect a setup terminal
to GR4000-80E1.
QSGGR4K00-10 5794047-1X
5.
Power on GR4000-