Quick Reference Guide; Hardness - Water Right Impression Series Installation Instructions & Owner's Manual

QUICK REFERENCE GUIDE

GENERAL OPERATION
When the system is operating, one of four displays will be shown:
1. Time of day/gpm
2. Flow rate
3. Capacity remaining
4. Days to a regen
5. Dealer name and phone number
Pressing ���� will toggle between the four choices.
TIME OF DAY MON CAPACITY REMAINING
8 2:40
GPM PM GPM
FLOW RATE DAYS TO A REGEN
8.0
GPM
GPM
TO SET TIME OF DAY
In the event of a prolonged power outage, time of day flashes, indicating
that this needs to be reset. All other information will be stored in memory
no matter how long the power outage.
1. Accessed by pressing �����
2. Adjust hours with + or — buttons, AM/PM toggles at 12
3. Press ����
4. Adjust minutes with + or — buttons
5. Press ����
6. Adjust current day with + or — buttons
7. Press ���� to complete and return to normal operation
TIME HOUR
2:00
AM
SET
MANUAL REGENERATION
NOTE: If you need to initiate a manual regeneration, either immediately, or
the same night at the pre-programmed time for regeneration (typically 2:00
AM), complete the following steps.
For Immediate Regeneration:
Press and hold ����� until valve motor starts (typically 3 seconds).
For Regeneration the same night:
Press and release ����� (notice that flashing "REGEN TODAY" appears).
REGEN TODAY and TIME OF DAY
will ash alternately if a regeneration
is expected tonight.
1600
8
GAL
PHONE NUMBER
DEALER NA
8 3
TIME MINUTES
2:00
SET AM
CURRENT DAY
MON
SET
REGEN TODAY MON
8 2:40
PM
GPM
ERROR
If the display toggles between "Error"
and an error code (i.e. a number), call a
service technician and report the error
code.
BYPASS VALVE OPERATION
To shut off water to the system, position arrow handles as shown in
the bypass operation diagram below. If your valve doesn't look like the
diagram below, contact your service technician for instructions on how to
shut off water.
NORMAL OPERATION
"TREATED" SUPPLY
WATER EXITS WATER ENTERS
ADJUST HARDNESS,
DAYS BETWEEN
REGENERATION, AND TIME
OF REGENERATION
For initial set-up or to make adjustments,
please complete the following steps.
1. Accessed by pressing ���� and + button
simultaneously
2. Adjust hardness using + or — buttons
3. Press ����
4. Adjust days between regenerations using
+ or — buttons
5. Press ����
6. Adjust time of regeneration hour with
+ or — buttons, AM/PM toggles at 12.
7. Press ����
8. Adjust time of regeneration minutes with
+ or — buttons
9. Press ����
10. Turn display backlight ON or OFF with
+ or — buttons. Default is ON.
11. Press ���� to complete and return to
normal operation.
27
CALL FOR SERVICE
ERROR
106
BYPASS OPERATION
SUPPLY SUPPLY
WATER EXITS WATER ENTERS
WATER HARDNESS
20
SET
GR
DAYS BETWEEN REGEN
12
SET
REGEN TIME HOUR
2:00
SET
AM
REGEN TIME MINUTES
2:00
SET
AM
LIGHT NORMALLY
ON
SET