Check The Original And Set It Again." Is Displayed; Change Direction Of Original" Is Displayed; Change From This Mode Count Over, Cannot Store Anymore." Is Displayed; Ready(*** Toner Not Recognized) Check The Toner Cartridge" Is Displayed - Toshiba E-STUDIO 2020AC Frequently Asked Questions Manual

9.QUESTIONS FOR ERROR MESSAGES
 "Check the original and set it again." is displayed.
This may occur due to the following causes. Check them and take the appropriate actions.
 The original is misfed inside of the ADF.
Remove the misfed original following the guidance on the touch panel.
 The direction or the size of the original placed on the ADF is incorrect.
Check the direction and the size of the original and then replace it on the ADF. Then reattempt the operation.
 "Change direction of original" is displayed.
The direction of the original placed on the original glass is incorrect. Change the direction of the original by 90 degrees
and place it on the original glass.
 "Change from this mode Count over, cannot store anymore." is displayed
The number of originals to be scanned has exceeded the limit specified with the department or user code during
scanning. For details of setting the limit for the number of copies, ask your administrator.
 "*** Ready(*** toner not recognized) Check the toner cartridge" is displayed.
This may occur due to the following causes. Check them and take the appropriate actions. (For color models, "***"
indicates the applicable color.)
The toner cartridge indicated by *** is not
installed at all or improperly so.
The terminal of the toner cartridge is stained.
The recommended toner cartridge is not being
used.
 "Ready (saddle stitch tray full)" is displayed.
The saddle stitch tray of the finisher is full of paper. Remove the paper from the saddle stitch tray of the finisher.
 "Ready (check saddle stitch stapler)" is displayed.
Staples in the stapler of the saddle stitch unit have almost run out or have actually done so. ***** Replace the staple
case of the saddle stitch unit if stapling is not performed for an output document even though the stapling function
has been selected. For details, see the reference below:
Troubleshooting - TROUBLESHOOTING FOR THE HARDWARE - Refilling With Staples - Saddle Stitch unit
 "Ready (Check Stapler)" is displayed.
A staple jam has occurred in the stapler of the finisher. Alternatively, the staple sheet has not been fed sufficiently.
Remove the top staple sheet. For details, see the reference below:
Troubleshooting - TROUBLESHOOTING FOR THE HARDWARE - Clearing a Staple Jam - Finisher
 "Ready (Check Stapler)" is displayed.
Staples in the stapler of the finisher have almost run out or have actually done so. ***** Replace the staple case of the
finisher if stapling is not performed for an output document even though the stapling function has been selected. For
details, see the reference below:
Troubleshooting - TROUBLESHOOTING FOR THE HARDWARE - Refilling With Staples - Finisher
 "Ready (hole punch dust bin is full)" is displayed.
The dust bin of the Hole Punch Unit is full. Remove the paper punchings. For details, see the reference below:
Troubleshooting - TROUBLESHOOTING FOR THE HARDWARE - Cleaning the Hole Punch Dust Bin
Install the toner cartridge correctly. For details, see the
reference below:
Troubleshooting - TROUBLESHOOTING FOR THE HARDWARE -
Replacing a Toner Cartridge
Clean the terminal with a soft cloth.
Use the recommended toner cartridge.
Questions for Error Messages 59