Prepare Engine For Long Term Storage; Prepare Pressure Washer For Storage - NorthStar 990994 Owner's Manual

Prepare Engine for Long Term Storage

First prepare the engine for long term storage if you
will not be using the pressure washer for more than
30 days.
Fuel can become stale when stored over 30 days. Stale
fuel causes acid and gum deposits to form in the fuel
system which can cause malfunction of the engine.
1. Prepare fuel system for storage:
• Drain all gasoline from the tank and
carburetor. This is most easily accomplished by
running the pressure washer with the high-
pressure hose until the engine stops from lack
of fuel. Drain carburetor bowl after engine has
stopped and has been allowed to cool for at
least two minutes.
OR
• Add fuel stabilizer to the gasoline (following
manufacturer's instructions)
Fuel stabilizer steps:
a. Ensure gas tank is full.
b. Add fuel stabilizer to fuel tank.
c. Run pressure washer with high pressure hose
at least 5 minutes after adding stabilizer to allow
it to enter the fuel system.
Storage
d. Shut off engine.
2. Lubricate cylinder and piston:
a. Disconnect spark plug wire and remove spark
plug.
b. Add one teaspoon oil through spark plug hole.
c. Place rag over spark plug hole and slowly pull
the recoil a few times to lubricate the
combustion chamber.
Replace spark plug, but do not reconnect the spark
plug wire.

Prepare Pressure Washer for Storage

1. Make sure the engine start switch is OFF.
2. Disconnect the engine spark plug wire if you haven't
already done so.
3. Disconnect the high-pressure hose, garden hose,
and spray gun.
Move Pressure Washer to Storage Location
Let engine cool for 5 minutes before moving the
pressure washer to its storage location.
21