Table of Contents
Advertisement
WARNING
High Pressure Fluid Injection Hazard
High-pressure fluid discharge from leaks (even pin-
sized) or ruptured components can pierce skin and
inject fluid into the body. Injection injury can result in
blood poisoning and/or severe tissue damage leading
to infection, gangrene, and possibly amputation.
• Never use a finger or skin to check for leaks.
• Never operate pressure washer with damaged or
missing hoses/parts.
• Never attempt to repair a high-pressure hose or
component – Always replace it with a part that is
rated at or above the pressure rating of this
pressure washer.
loose connections
•
loose or missing fuel hose clamps
•
damaged fuel tank or
•
defective gasoline shut-off valve
•
Inspect Pressure Washer Spray System
Always inspect pressure washer spray system for
damage and leaks before each use. Do not start
pressure washer until all needed repairs have been
completed.
Perform Scheduled Maintenance, As needed
Make sure that any other regular maintenance has been
performed as prescribed in this manual in the
"Maintenance Schedule Summary" section.
Refer to the engine Owner's manual for engine
maintenance instructions.
Connect Hoses, Water Supply, and Spray
Position Pressure Washer for use
For detailed instruction on positioning your pressure
•
washer for use, turn to the "Initial Set-Up" section of
this manual and reference "Step 3: Select Suitable
Location".
Where no flammable vapors, dusts, and gases are
•
present.
Where there is adequate, unobstructed ventilation
•
airflow.
With adequate clearance from combustible
•
materials.
On a firm, level, heat-resistant surface with good
•
drainage and nearby access to a continuous water
supply.
Nozzle
Operation
Fill Water Tank or Attach Garden Hose to
Water Inlet
1.) Make sure the water supply is clean. Debris can
cause excess pump wear and reduce performance.
2.) An insufficient water supply will damage your pump.
Make sure the water supply is steady and is 20%
over the rated flow of your pump. Use a stopwatch
to time how long it takes to fill a 5-gallon bucket with
your garden hose. The bucket must fill faster than
the times listed in the table below.
Model#
990994
3.) The water supply garden hose must have an inside
diameter of at least 5/8". If the hose is more than 100
ft. long, the diameter must be at least 3/4".
4.) Always use a flexible rubber hose for your water
supply. Do not use rigid piping.
Attach High Pressure Hose to Spray Gun
NEVER operate this pump with components (such as
hose, connections, and spray gun) rated for lower
pressure and/or temperature limits than the pressure
washer's maximum rated pressure and temperature,
or component could rupture and cause serious
personal injury from escaping high pressure fluids.
1. See "Component Identification" section of this
manual for location of the pressure washer's water
outlet.
2. Your pressure washer hose is equipped with quick
couplers. Simply pull the collar back and push the
coupler onto the water outlet nipple. The collar
should slide over the ball bearings.
16
Time to Fill 5 Gallon
Bucket
72 sec
and Water Outlet
WARNING
High Pressure
Advertisement
Table of Contents
