Table of Contents
Advertisement
EN
Care and maintenance
General Cleaning
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
3. Check for any damage and wear. Repair damages in accordance with this
instruction manual or take it to an authorised service centre before using the
product again.
Spare parts / Replacement parts
The following parts of this product may be replaced by the consumer. Spare
parts are available at an authorized dealer or through our customer service.
Underbody and cutting blade
WARNING! Wear safety gloves when working on the blade and close
to it! Use proper tools to remove debris, e. g. a wooden stick! Never
use your bare hands!
Always use original spare parts for replacement. The cutting blade
must be replaced by an identification no. ref. A056019100. Do not
attach any other type of cutting blade!
The replacement of the cutting blade should be done by a qualified
specialist! Rework or sharpening blades is not recommended unless
it is done by a repair service or a similarly qualified specialist!
1. Keep the underbody and cutting blade (13c) clean and free of debris. Remove
clippings from the rear discharge chute (19).
2. Check all fasteners, such as nuts and bolts, periodically for tightness before
operation. After prolonged use, especially in sandy soil conditions, the cutting
blade will become worn and lose some of the original shape. The cutting
efficiency will be reduced and the cutting blade should be replaced.
3. Keep the cutting blade (13c) sharp to ensure a good cutting performance.
Replace a worn or damaged cutting blade with a new one of the same type or
have it sharpened by a qualified specialist.
4. Loosen the hex nut (13d) anti-clockwise using a suitable wrench (Size 17 mm)
and remove it together with the cutting blade (13c) (Fig. 18).
5. Replace the cutting blade (13c) with a new one of the same type. Check the
status of the flange (13b) onto the spindle (13a) firstly, then attach the cutting
blade (13c) and hex nut (13d) properly. Tighten the hex nut (13d) clockwise
28
with 20 Nm min, 25 Nm max. to ensure safe operation of your product.
MLM1841 by MacAllister
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MLM1841 and is the answer not in the manual?
Questions and answers
Have you any photos that show switch assembly, my daughter removed the cover on her lawn mower and not sure if she has lost a part but doesn’t assemble correct
Has anyone a photo or diagram of switch assembly for Mac MLM1841
The document mentions figures (e.g., Fig. 3, Fig. 4, Fig. 5, Fig. 6) related to assembly and components of the Mac Allister MLM1841, but it does not explicitly confirm the presence of a photo or diagram of the switch assembly.
This answer is automatically generated
Does anyone know the size of the nut that secures the cutting blade on an MLM1841?