Partial Reset; All Reset - Icom IC-R20 Instruction Manual

11
OTHER FUNCTIONS

■ Partial reset

If you want to initialize the operating conditions (VFO fre-
quency, VFO settings, set mode contents) without clearing
the memory contents, a partial resetting function is available
for the receiver.
➥ While pushing [VFO MHz], turn the power ON to partially
reset the receiver.
DUALWATCH MAIN/SUB POWER
VFO MODE MR
BAND
MHz SCAN S.MW
DIAL.SEL SWEEP CENTER
1 2 3
SCOPE
T-SCAN SKIP M.N
4 5 6 0
AFC
TONE SET TS
7 8 9
LOCK
ATT RF GAIN IC Recorder
REC
67
POWER ON
AT
TSQL
-DUP
POWER
MODE FM ANL
146 010
VFO
MHz
PSKIP
√
*The appearing frqeuency is
different according to re-
ceiver version.

■ All reset

The function display may occasionally display erroneous in-
formation (e.g. when first applying power). This may be
caused externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting for a few
seconds, turn power ON again. If the problem persists, per-
form the following procedure.
• Partial resetting is also available. See left for details.
AFC
IMPORTANT!:
Resetting the receiver (All reset) CLEARS all memory in-
formation and initializes all values in the receiver, includ-
ing TV channel skip setting.
➥ While pushing [VFO MHz] and [MR S.MW], turn the power
ON to reset the CPU.
DUALWATCH MAIN/SUB
VFO MODE
BAND
MHz SCAN
DIAL.SEL SWEEP CENTER
1 2 3
T-SCAN SKIP M.N
4 5 6
TONE SET TS
7 8 9
ATT RF GAIN IC Recorder
AT
ALL-RESET
POWER POWER
MR
MR
S.MW
S.MW
SCOPE VFO
TSQL
-DUP
MHz
MODE FM
146 010
0
AFC
LOCK
√
REC
*The appearing frqeuency is
different according to the
receiver version.
POWER ON
AFC
ANL
PSKIP