DeWalt 20V MAX DCN890 Instruction Manual page 76

ENGLISH
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Lubrication
NOTICE: NEVER spray or
in any other way apply
lubricants or cleaning
solvents inside the tool.
This can seriously affect
the life and performance of
the tool.
D WALT tools are properly lubricated at the factory and are
E
ready for use. However, it is recommended that, once a year,
you take or send the tool to a certified service center for a
thorough cleaning and inspection.
Accessories
WARNING: Since accessories, other than those
offered by D WALT, have not been tested with this
E
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
DCN8901 Driver Blade Replacement Kit
DCN8902 Magnetic Stick-E Contact Trip
DCN8903 Stick-E Contact Trip
DCN8904 Standard Contact Trip
DCN8905 Pole Tool
DCN8902: Magnetic Stick-E Contact Trip
(Fig. L)
For some applications, using a Stick-E contact trip may
be desirable.
WARNING: For your own safety, read the tool
instruction manual before using any accessory.
Failure to heed these warnings may result in personal
injury and serious damage to the tool and the
accessory. When servicing this tool, use only identical
replacement parts.
To Replace Contact Trip
1. Push down on the contact trip release lever.
2. Pull the contact trip out of the nose of the tool.
3. Hold down the trip release lever
4. With the contact trip alignment marker facing up, as
shown in Figure L, insert the contact trip fully into
the tool nose.
5. Release the lever.
14
Fig. L
DCN8901 Driver Blade Replacement Kit
(Fig. M, N, O)
WARNING: For your own safety, read the tool
instruction manual before using any accessory.
WALT
E
Failure to heed these warnings may result in serious
personal injury and damage to the tool and the
accessory. When servicing this tool, use only identical
replacement parts.
NOTICE: All the mechanical parts of the driver
replacment kit are shown for convenience and
verification of inclusion.
To change a worn driver:
1. Using a T-20 Torx, loosen the four screws
side of the unit. Refer to Figure M.
2. Remove the four screws and the removable top
stand
7
3. Remove housing end cap
Fig. M
4. Push up on the rear of the driver
click, then push the driver forward while holding it in
this position until it passes the upper bumper assembly.
Refer to Figure O.
5. Remove guide rods
6. Remove upper bumper assembly
6
. Refer to Figure M.
19 . Refer to Figure M.
7
21 . Refer to Figure O.
5
18 on either
19
18
20 until you hear a
. Refer to Figure N.
22