Table of Contents
Advertisement
2-11. GEARS INSTALLATION
3 gear (gear B)
portion A
Adjust the gear (gear B) with the
portion A as shown.
1 Slide the slider (U/D)
fully in the arrow
direction.
2 gear (U/D slider)
slider (U/D) gear
Adjust the gear so that it meshes with
the bottom tooth of slider (U/D)gear,
as shown.
2-12. SLIDER (SELECTION) INSTALLATION
2 gear (chuking)
rotary encoder
Align with the slot of
rotary encoder.
1 rotary encoder
align marking
12
gear
(gear B)
6 two screws
(PTPWH M2.6)
5 washer
4 compression spring
7 Insert the slider (selection)
into the portion A.
3 convex portion of
gear (chuking)
Insert a convex portion into
a groove of gear (chuking).
4 gear (gear A)
linearly
Adjust so as to be aligned with
gear (B) linearly,as shown.
portion A
slider (selection)
Advertisement
Table of Contents
