Connection/Installation; Cautions; Parts List For Installation - Sony MEX-N5200BT Operating Instructions Manual

F:\#Work#\0830\4597143611\4597143611MEXN5200BTUC\01GB-
MEXN5200BTUC\040CD.fm
010COV.book Page 37 Tuesday, August 30, 2016 3:16 PM

Connection/Installation

Cautions

• Run all ground (earth) leads to a
common ground (earth) point.
• Do not get the leads trapped under a
screw, or caught in moving parts (e.g., seat
railing).
• Before making connections, turn the car
ignition off to avoid short circuits.
• Connect the yellow and red power supply
leads only after all other leads have been
connected.
• Be sure to insulate any loose unconnected
leads with electrical tape for safety.
Precautions
• Choose the installation location carefully so
that the unit will not interfere with normal
driving operations.
• Avoid installing the unit in areas subject to
dust, dirt, excessive vibration, or high
temperature, such as in direct sunlight or
near heater ducts.
• Use only the supplied mounting hardware
for a safe and secure installation.
Note on the power supply lead (yellow)
When connecting this unit in combination with
other stereo components, the amperage rating of
the car circuit to which the unit is connected must
be higher than the sum of each component's fuse
amperage rating.
Mounting angle adjustment
Adjust the mounting angle to less than 45°.
masterpage: Right

Parts List for Installation

5 × max. 8 mm
( 7 /
32
• This parts list does not include all the
package contents.
• The bracket and the protection collar
are attached to the unit before shipping.
Before mounting the unit, use the release
keys to remove the bracket
unit. For details, see "Removing the
protection collar and the bracket"
(page 40).
• Keep the release keys for future use as
they are also necessary if you remove the
unit from your car.
× 2
× max. 5 / in)
16
× 4
from the
37
GB
MEX-N5200BT
4-597-143-61(1)