Rear Discharge; Operation; Installing And Removing The Battery - DeWalt DCMW220X2 Instruction Manual

Fig. E
5
9
8
Grass Collection Bag (Fig. F)

DANGER: Remove safety key and battery packs before
removing mulching insert, and when opening rear
door cover and installing bag.
1. Ensure the mulching insert
the mower before proceeding to step 2.
2. Lift the rear door cover
collection bag 14 onto the mower so the bag
hooks 21 rest on the lugs
lower the rear door cover.
Fig. F
Grass Mulching Insert (Fig. G)

DANGER: Remove safety key and battery packs
before removing collection bag, and when installing
mulching insert.
1. Ensure the the grass collection bag
before proceeding to step 2.
2. Lift the rear door cover
insert 20 fully into the mower as shown in Fig. G.
20 (Fig. G) is removed from
13 and place the grass
22 as shown in Fig. F. Then
13
22
21
14 is not attached
13 and slide the mulching
3. Ensure the rear door cover is down before turning
mower on.
Fig. G
7

Rear Discharge


DANGER: Remove safety key and battery packs before
removing collection bag, and mulching insert.
1. To operate mower in rear discharge mode remove both
the bag and the mulching insert.
2. Be sure rear door cover is down for rear discharge.
nOTE: The rear door is shaped in such a way that the
opening (at the bottom) cannot be completely closed off.

OPERATION


DANGER: To reduce the risk of serious personal
injury, turn unit off, remove safety key, and
remove battery packs before making any
adjustments or removing/installing attachments
or accessories. An accidental start-up can
cause injury.

Installing and Removing the Battery

Packs (Fig. H)

DANGER: MAKE CERTAIN THE SAFETY KEY IS
REMOVED TO PREVENT ACTUATION BEFORE
REMOVING OR INSTALLING BATTERY.
This mower is designed to operate on two battery packs
of equal capacity. The mower will not operate on a single
battery pack, and If using different capacity battery packs,
the smaller capacity battery pack, when depleted, will cause
the unit to turn off
nOTE: For best results, make sure each battery pack is
fully charged.
14
To Install Battery Packs
1. Lift and hold the battery port cover
the battery ports
2. Slide a battery
until an audible click is heard (Fig. H). Make sure
the battery packs are fully seated and fully latched
into position.
3. Close the battery port cover. Ensure the cover is fully
closed before starting mower.
To Remove Battery Packs
1. Open the battery port cover
11
21 .
18 into each of the two battery ports
11 as described above.
English
20
up to expose
9