Fig. 62: Fitting The Locking Device; Table 42: Locking Device Tightening Torque - ABB HT575729 Operation Manual

Operation Manual / 4 Product description / A100-M axial
9 Taking a turbocharger out of operation / 9.2 Locking the rotor
9.2.2 Fitting the locking device
CAUTION
Turbocharger damage resulting from rotor unbalance
Removing the balancing screws from the compressor wheel will result in ro-
tor unbalance.
Only use free threaded holes to fit the lifting spigot (74027).
u
Remove filter silencer or air suction branch (see chapter entitled
u
inlets →52).
Fig. 62: Fitting the locking device
Product
A170-M
A175-M
Table 42: Locking device tightening torque
1. Press off the spinner nose cone (25012) with the press-off screw (90917).
2. Remove two studs (72026) and three screws (72011) in the upper area.
3. Insert lifting spigot (90427) into compressor wheel.
Screw screws (94007) into the free threaded holes of the compressor wheel.
4. Position assembly/disassembly device (94003) with screws (72011) and lifting spigot
(90427).
Rotate the compressor wheel so that the holes in the lifting spigot (90427) align with the
holes in the assembly/disassembly device (94003).
5. Fasten assembly/disassembly device (94003) to lifting spigot (90427) with screws
(94006).
© Copyright 2017 ABB. All rights reserved.
Part number 72011
170 Nm
220 Nm
HZTL4033_DE
Removing / Installing air-
Part number 94006 / 94007
25 Nm
50 Nm
Revision B December 2017