Canon Multi Function Professional Puncher-B1 Operation & Instruction Manual page 8

Messages on the LCD Panel (continued)
12. Close Door
When the Front door is open or not completely closed this message
will be displayed.
13. Paper Jam
When a sheet of paper becomes jammed within the punch unit, this
message is displayed. See the section of this manual titled PAPER
CLEARING for instructions on how to remove a jammed sheet.
Changing the Settings on the LCD panel
1. Mode
With the Crease die inserted, crease function can be turned
ON/OFF. REG.ACCURACY can be turned ON/OFF and can
improve the position and reliability of the crease. However, some
decrease in system productivity may occur in this mode even if the
crease die is not inserted.
Double punch mode will be visible only if the setting is turned on in
service settings. Contact your authorized dealer to enable double
punching if this mode is not visible.
2. Backgage Depth Setting
Backgage is the distance of the punched hole(s) from the trail edge
of the sheet. This distance can be adjusted by entering the Settings
section (press Up or Down from the Home screen, and press OK
for Settings).
Pressing Up arrow will increase the Depth of Backgage, and
Pressing Down arrow will decrease the Depth of Backgage.
"-"ON THE LCD
DECREASES
BACKGAGE
DEPTH
Multi Function Professional Puncher – B1
BACKGAGE
"+"ON THE LCD
INCREASES
BACKGAGE
DEPTH
The settings for backgage MID L and MID XL adjust the backgage of the
double punch mode. MID L and MID XL function the same as the regular
backgage depth, but adjust the position of the middle punch.
MID L adjusts backgage for SEF letter and SEF A4, while MID XL adjusts
backgage for SEF 11x17 and A3
"-" ON THE LCD
DECREASES
BACKGAGE
DEPTH
When a crease die is inserted, the Backgage Depth options are:
1 Crease Mid
CR EASE L I N E
"+" O N T H E LC D
M O VES T H E
CR EASE L I N E I N
T H I S D I R E C TIO N
BACKGAGE
"+" ON THE LCD
INCREASES
BACKGAGE
DEPTH
"-" O N T H E LC D
M O VES T H E
CR EASE L I N E I N
T H I S D I R E C T IO N
PAPE R F L OW D I R E C T IO N
EN
8