Download Print this page

Advertisement

Quick Links

A18CS57BL
Original instructions

Advertisement

loading

Summary of Contents for AEG A18CS57BL

  • Page 1 A18CS57BL Original instructions...
  • Page 2 Important! It is essential that you read the instructions in this manual before assembling, operating and maintaining the product.
  • Page 3 Front handle Handle, insulated gripping surface Lock-off button Switch trigger Spindle lock button Dust pipe joint Lower guard handle Bevel adjustment knob Blade Edge guide fence Outer flange Blade screw Hex key Battery port Depth adjustment lock lever Rafter hook...
  • Page 4 90°...
  • Page 5 START STOP...
  • Page 6 Remove the battery pack before starting any work on the product. click...
  • Page 7 75-100 % 50-75 % 25-50 % 0-25 %...
  • Page 9 EN 847-1...
  • Page 10 Adjust the cutting depth to the thickness of the workpiece. Less than a full tooth of the blade teeth should be visible below the workpiece. 0 - 57 mm...
  • Page 12 0 - 50°...
  • Page 13 0 - 18 cm 45° 0°...
  • Page 14 START STOP...
  • Page 15 Handle (insulated gripping surface)
  • Page 16 2 START 0° STOP...
  • Page 17 0° > 0° 3 START STOP...
  • Page 18 90° to the saw blade is necessary, use the correction screw. 0° 0° 90°...
  • Page 20 ø 30 mm...
  • Page 21 max. 57 mm > 57 mm...
  • Page 25: Technical Data

    TECHNICAL DATA A18CS57BL Type Circular saw Battery voltage 18 V Saw blade dia. x hole dia. 1.6 mm Blade teeth Weight without battery pack Noise Information levels of the tool are: Wear ear protection! Vibration Information Cutting board WARNING! The declared vibration total values and the declared noise emission values given in this instruction manual have been measured in accordance with a standardised test and may be used to compare one tool with another.
  • Page 26: Specified Conditions Of Use

    If a saw blade binds, it may walk up or kickback from the workpiece ADDITIONAL BATTERY SAFETY WARNINGS as the saw is restarted. WARNING! product damage due to a short circuit, never immerse your tool, Large panels tend to sag under their own weight. Supports must be placed under the panel on both sides, near the line of cut and near the edge of the panel.
  • Page 27: Maintenance

    • Ensure that battery contact terminals are protected and insulated Wear protective gloves. to prevent short circuit. • Ensure that battery pack is secured against movement within packaging. • Check with forwarding company for further advice. BATTERY PACK PROTECTION LI-ION BATTERY The battery pack has overload protection that protects it from being Rotation direction battery electronics switch off the machine automatically.
  • Page 28 Techtronic Industries Australia Pty Ltd 31 Gilby Road, Mount Waverley, VIC, 3149, Australia Techtronic Industries N.Z. Limited AEG is a registered trade mark used under Unit C, 70 Business Parade South, license from AB Electrolux (publ). Highbrook, Auckland 2013, New Zealand...