Page 2
mportant! It is essential that you read the instructions in this manual before assembling, operating, and maintaining the product. Subject to technical modifications.
Page 11
Adjust the cutting depth to the thickness of the workpiece. Less than a full tooth of the blade teeth should be visible below the workpiece. Doing this provides increased cutting efficiencies and longer runtimes.
Page 12
START For safety reasons this power tool is fitted with a switch lock and the On-/Off switch cannot be locked in the “On” position. STOP...
Page 14
Insert and screw to lock in place. Carry out test cut where possible.
Page 15
Accessory can be attached to a dust extraction unit. ø 30 mm Always connect the dust pipe joint to the circular saw before using. Always connect the vacuum attachment to a standard vacuum hose.
Page 16
If a correction of the 90˚ angle of the guide-plate to the saw blade is necessary, use the correction screw. 90˚...
Page 18
This tool is equipped with LED lights for work piece illumination. The LED can be activated by either the trigger when the saw is running or by the handle switch without the saw running.
Page 19
Replace the dust pipe joint if worn or broken before use.
Page 21
Let the tool do the work. Pushing this saw will reduce efficiencies. 68mm...
Page 22
Always work on a stable, level work piece. Guide rail sold separately: 4932430067 Guide rail adaptor sold separately: 4931416518...
L1890R hardware of the saw will run eccentrically, causing loss of control. Use AEG 18V battery and charger only Never use damaged or incorrect blade washers or bolt. The blade washers and bolt were specially designed for your saw, for optimum WARNING! performance and safety of operation.
Page 24
side of the blade, but not in line with the blade. Wear a dust mask. Kickback could cause the saw to jump backwards, but kickback forces Do not fix the on/off switch in the “on” position when using the saw can be controlled by the operator, if proper precautions are taken.
Use only AEG accessories and AEG spare parts. Should components SPECIFIED CONDITIONS OF USE need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service The product is designed for rip- and cross-cutting of wood or similar addresses).
Page 28
Techtronic Industries Australia Pty Ltd 31 Gilby Road, Mount Waverley, VIC, 3149, Australia Techtronic Industries N.Z. Limited Unit C, 70 Business Parade South, Highbrook, Auckland 2013, New Zealand AEG is a registered trademark used under 961099007-01A license from AB Electrolux (publ).