Advertisement
Available languages
Available languages
10 Charger
11 Charging indicator (red)
INTENDED USE
Your cordless drill/driver DC600 has been designed
for light drilling and screwdriving applications.
DO NOT use this tool under wet conditions or in
presence of flammable liquids or gases.
This rotary drill is a professional power tool.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators
use this tool.
Auto-spindle lock
The auto-spindle lock is engaged when the
transmission is stationary.
Electrical Safety
The electric motor has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger
corresponds to that of your mains.
Your D
WALT charger is double insulated
E
in accordance with EN 60335; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D
WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the
plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made
to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger (see
technical data). The minimum conductor size is
1 mm
2
; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENT
WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
WARNING: Use only D
packs and chargers.
Inserting and Removing the Battery Pack
● Insert the battery pack into the grip until it clicks
in place.
● To remove the battery pack, press the two
release buttons (9) simultaneously and pull the
pack out of the grip.
Inserting and Removing Bits (fi g. A & C)
● Pull the sleeve (13) forwards and insert the
screwdriver bit (14).
● Release the sleeve.
● To remove the bit, pull the sleeve forwards and
pull the bit out of the holder.
Pivoting the Tool Head (fi g. D)
The head of the tool can be pivoted for optimum
versatility.
● Press either the left or right pivot release button
(3).
● Pivot the tool head to one of the three preset
pivot positions.
● Release the button.
Selecting the Operating Mode or Adjusting the
Torque (fi g. E)
The collar of this tool has 8 positions for the
adjustment of the torque to suit the size of the
screw and the workpiece material. For torque
adjustment, refer to the section "Screwdriving".
● Select the drilling mode or torque by aligning
the indicator on the collar (4) with the symbol or
number on the housing.
Forward/Reverse/Lock off Slider (fi g. F)
● To select forward or reverse rotation, use the
forward/reverse slider (2) as shown (see arrows
on the slider).
WARNING: When the slider is in the
central position the tool is locked off to
prevent accidental actuation or battery
discharge.
E N G L I S H
WALT battery
E
33
Advertisement
