Hp Setup Program - HP Vectra VL6 7 User Manual

First, Turn On or Restart
Your PC
To Go to the HP
Summary Screen
To Go to the Setup
Program
To Go to the Boot Menu

HP Setup Program

Follow these instructions to check your PC's configuration when you
first use the PC:
If your PC is off, turn on the display and then the PC.
If the PC is already turned on, save your data, exit all programs and
restart your PC. For Windows NT 4.0 or Windows 95, use the Shut
Down – Restart your computer command in the
This command will automatically exit the operating system and restart
the PC. For operating systems such as Windows NT 3.51, you must exit
the operating system and then manually switch off and then on the PC,
using the power on/off button.
While the Vectra logo appears on your display, press
you to the HP Summary Screen. The Summary Screen will appear for
only a short time. To retain the screen indefinitely (until you decide to
leave it), press .
The summary screen shows the basic configuration of your PC, such as
the amount of main memory.
To go immediately into the Setup program while the Vectra logo
appears on your display (and bypass the Summary Screen), press
instead of .
The Setup program allows you to view and change the configuration of
your PC, such as the passwords and standby (power saving) mode.
To go to the Boot Menu while the Vectra logo appears on your display,
press .
The Boot Menu shows the order of devices which the PC attempts to
start from (flexible disk drive, CD-ROM drive, hard disk drive, and
network). From this menu you can also enter the Setup program to
change the boot order.
3 Troubleshooting Your PC
HP Setup Program
menu.
Start
. This will take
English 39