Siemens WG44G2A0EP User Manual And Installation Instructions page 43

Table of Contents

Advertisement

Fault
"E:30/-20"
The appliance is not
working.
The programme does
not start.
Cause and troubleshooting
If you dose manually, reduce the amount of deter-
gent for the next washing cycle with the same load.
Additional water is added.
Do not add any extra water to the appliance while it
is operating.
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
There has been a power cut.
Check whether the lighting in your kitchen or other
appliances are working.
You have not pressed  inicio pausa + carga .
Press inicio pausa + carga .
Door is not closed.
Close the door.
1.
Press inicio pausa + carga to start the pro-
2.
gramme.
Childproof lock is activated.
→ "Deactivating the childproof lock", Page 32
⁠   termin. is activated.
Check whether
→ "Buttons", Page 23
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press inicio pausa + carga to start the pro-
4.
gramme.
The detergent drawer has not been pushed in fully.
Push in the detergent drawer until the symbol goes
out.
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page 35
Switch the appliance on.
3.
If the display appears again after you clean the
4.
pump unit, call customer service.
→ "Customer Service", Page 52
⁠   termin. is activated.
Troubleshooting en
43

Advertisement

Table of Contents
loading

Table of Contents