HP Vectra VE5 4 Installation Manual page 3

1 Connecting to a Netware 3.12 Server
Windows for Requirements
Workgroups
• HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.
• 3COM Etherlink 3C509-B ethernet card and drivers disk ver. 5.0.
• DOS and MS-Windows for Workgroups 3.11 media.
• Novell Netware server 3.12 that supports Net BEUI, NWLink IPX/SPX,
• Netware client for DOS and MS-Windows.
Device Configuration
• I/O Base Address
• Interrupt Request Level
• Boot PROM
• Transceiver Type
• Network Driver Optimization
• Maximum Modem Speed
• Plug and Play Compatibility
• Full Duplex
Procedure
1 With the HP Vectra turned off install the 3COM Etherlink III 3C509-B
2 Power on the machine and allow it to boot to a DOS prompt.
3 Insert the 3COM drivers diskette (ver. 5.0 downloaded from 3COM's
4 Select "CONFIGURE NIC," and verify the resource settings listed above
5 If changes are required, save those changes and exit.
DOS ODI - File Name: 3C5X9.COM Size: 42KB Date: 7/21/96
and NWLink NetBIOS transfer protocols.
adapter card into an ISA slot.
website) and execute 3C5X9CFG.EXE.
under the heading "Device Configuration."
1 Connecting to a Netware 3.12 Server
Windows for Workgroups
300
10
Disabled
Auto Select
Windows or OS/2 Client
9600 Baud
Disabled
Disabled