Table of Contents
Advertisement
9.3 Pulling and Gland Ducted Cables
Step No.
2
NOTE: It is recommended that the Ethernet cable, if fitted, is pulled through all
conduits prior to attaching the RJ45 termination jack. This ensures the
termination is not compromised in any way during the pulling procedure. See
section 9.10 for termination details
NOTE: Sharp bends in all cables are to be avoided. A minimum bend radius of
4x the cable diameter should be observed where possible.
1. Pull all external cables through underground ducting and up into the cabinet via
the aperture in the left of the stool by the CET plate. See section 7 for details on
external cabling.
Version
7
Last Editor
Ore Oluwatudimu
Document
UPS Solution General Handbook
Name
Copyright ã Siemens plc 2017 All Rights Reserved
Figure 9-2: Stool Installation Diagram
UPS Cabinet
Pull and gland ducted cables
Page 30 of 76
TS008468
Infrastructure and Mobility, Traffic Solutions
Battery Expansion Cabinet
Status
ISSUED
Date
31/01/2017
Doc. No.
667/HB/47750/000
Sopers Lane, Poole, Dorset
BH17 7ER
Refer to
Section 9.3
Advertisement
Table of Contents
