VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage.
By clients in hotels, motels, bed and breakfast and other – residential type environments. To avoid contamination of food respect the following • instructions: do not open the door for long periods; – clean regularly surfaces that can come in contact with food –...
• Make sure the air can circulate around the appliance. The appliance contains flammable gas, • At first installation or after reversing the door isobutane (R600a), a natural gas with a high level wait at least 4 hours before connecting the of environmental compatibility.
SERVICE • Disconnect the appliance from the mains supply. • To repair the appliance contact the Authorised • Cut off the mains cable and discard it. Service Centre. Use original spare parts only. • Remove the door to prevent children and pets to •...
Page 6
DIMENSIONS Overall dimensions ¹ Overall space required in use ³ 1180 1209 ¹ the height, width and depth of the appliance ³ the height, width and depth of the appliance without the handle including the handle, plus the space necessary for free circulation of the cooling air, plus the space necessary to allow door opening to the minimum Space required in use ²...
Page 7
in a place with direct sunlight. Make sure that air WARNING! This appliance must be can circulate freely around the back of the cabinet. earthed. This appliance should be installed in a dry, well The manufacturer declines any liability ventilated indoor position. should these safety measures not be To ensure best performance, if the appliance is observed.
6. Lift the door and put it on a soft surface. WARNING! A cut off plug inserted 7. Tilt the appliance carefully on a soft foam into a 13 amp socket is a serious packaging or similar material to avoid any safety (shock) hazard.
Install the door equipment. Wait at least 4 hours before connecting the appliance to the power supply. OPERATION SWITCHING ON • room temperature, • frequency of opening the door, 1. Insert the plug into the wall socket. • quantity of food stored, 2.
1. Place the shelf flat on the door. To ensure correct air circulation, do 2. Push two sides of the shelf downwards at the not move the glass shelf above the same time so that the shelf fits both fasteners. vegetable drawer.
CARE AND CLEANING 2. Regularly check the door seals and wipe them WARNING! Refer to Safety chapters. clean to ensure they are clean and free from debris. 3. Clean the condenser with a brush at least twice a year. CLEANING THE INTERIOR 4.
Page 12
Problem Possible cause Solution Many food products were put Wait a few hours and then in at the same time. check the temperature again. The room temperature is too Refer to "Installation" chapter. high. Food products placed in the Allow food products to cool to appliance were too warm.
Page 13
Problem Possible cause Solution Water flows inside the refriger- Food products prevent the wa- Make sure that food products ator. ter from flowing into the water do not touch the rear plate. collector. The water outlet is clogged. Clean the water outlet. Water flows on the floor.
NOISES SSSRRR! BRRR! CLICK! HISSS! BLUBB! TECHNICAL DATA The technical information is situated in the rating It is also possible to find the same information in plate on the internal side of the appliance and on EPREL using the link https://eprel.ec.europa.eu the energy label.
ENVIRONMENTAL CONCERNS with the symbol with the household waste. Recycle materials with the symbol . Put the Return the product to your local recycling facility or packaging in relevant containers to recycle it. Help contact your municipal office. protect the environment and human health by recycling waste of electrical and electronic appliances.