Kenwood DMX8021DABS Quick Start Manual page 16

Connection/Installation
Ñ
Connecting wires to terminals
Accessory 1
Light Blue/Yellow
(Steering remote control wire)
Blue/White
[1]
(Power control/Antenna control wire)
Brown
(Mute control wire)
Green/White
Green/Red
Purple/White
(Reverse sensor wire) (2 m)
Pink
(Speed Pulse Input) (2m)
Light Green
(Parking sensor wire) (2 m)
For best safety, be sure to connect
the parking sensor.
[1] [2]: Blue/White wire is provided two wires, [1] and [2]. Blue/White wire total output ([1] + [2]): 12 V = 350 mA
16
Fuse (15A)
REMOTE CONT
P. CONT
PRK SW
Other cable : Not used.
A: Black (Ground wire)
B: Yellow (Battery wire)
C: Red (Ignition wire)
A
If no connections are made, do not let the cable
come out from the tab.
To steering remote
To use the steering wheel remote control feature,
STEERING WHEEL
you need an exclusive remote adapter (not supplied)
REMOTE INPUT
matched to your car.
Connect either to the power control terminal when
using the optional power amplifier, or to the power
ANT CONT
terminal for the booster amplifier of the film-type or
short pole type antenna.
Connect to the terminal that is grounded when either
MUTE
the telephone rings or during conversation.
To CMOS-3xx series (optional accessory) camera
CAM–
control terminal
CAM+
Connect to vehicle's reverse lamp harness when using
the optional rear view camera.
REVERSE
Connect to the vehicle's speed pulse harness.
S SENS
Do not cut the "S SENS" tag or failure may result.
Connect to the vehicle's parking brake detection switch
harness.
B C
Connector A
8 6 4
7 5 3
8 6 4
7 5 3
Connector B
2
1
2
1