Installing Cartridge Group - ABB HT576676 Operation Manual

8.7
8.7
CAUTION
TPL65-A32/33/36
TPL69-A32/33
© Copyright 2016 ABB. All rights reserved.
Operation Manual / TPL65-A32 / -A33 / -A36 + TPL69-A32 / -A33
Disassembly and assembly

Installing cartridge group

Installing cartridge group
Oil orifice plates
An orifice plate for adjusting the oil pressure is fitted in each of the two
oil inlet channels in the bearing casing. When the cartridge group, the
bearing casing or the turbocharger is fitted to the engine, it must be en-
sured that the orifice plates that are specified for the turbocharger have
been installed in the two oil inlet channels.
Check correct installation of oil orifice plates.

Figure 2
Remove cover from oil connection.

Secure separate lifting gear to each of two ribs on bearing casing pro-

vided for this purpose.
Remove supports (90450) and carefully insert cartridge group.

Evenly tighten the three screws (61059) together with Verbus Ripp®

washers (61058) to the specified tightening torque (see chapter Table
of tightening torques).
Evenly tighten screw (61059) together with Verbus Ripp® washers

(61058) and two nuts (61037) to the specified tightening torque (see
chapter Table of tightening torques).
8
8.7 Page 99