Water Connection; Water Supply - Bosch WKD28350GB Installation Instructions, Instructions for Use, Programme Table Installation And Operating Instructions Manual

Dimensions
Width x depth x height
Hose and cable lengths
Left-hand connection
approx. 1350
min.
500
max.
approx. 1400
900

Water connection

Water supply

* depends on the model
Weight
approx. 1400
To prevent leaks or water damage, you must observe the instructions in
this section.
If in doubt, have a technician connect the appliance.
The water supply and drain hoses can be routed to the left of right,
depending on installation conditions.
Do not use a used inlet hose. Only use the inlet hose supplied or one
which was purchased from an authorised specialist retailer.
Do not allow the water supply hose to be:
– kinked or squashed,
– altered or cut (strength no longer guaranteed).
Note the water pressure in the mains supply:
The water pressure should be between 50-900 kPa (0.5-9 bar) (at least
8 litres of water flow out per minute when the tap is turned on).
If the water pressure is higher, a pressure reducing valve must be fitted.
Connect the cold-water supply hose (blue union nut) to the cold water tap
with ¾" pipe (3/4" = 26,4 mm) thread.
Only tighten plastic screw connections by hand.
Do not remove the filter from the supply hose.
After connecting the water supply hose:
– Turn the tap on fully.
– Check the connections for leaks.
595 mm x 584 mm x 820 mm
85 kg
or
approx. 1000
Right-hand connection
approx.
760
approx. 950
Dimensions in mm
min.
500
max.
900
26