Keep all documents in a safe place for future reference, or to pass on to the next owner. For further information and a selection of our products, visit our website: www.bosch-home.com General safety information ... 3 Environmental protection/economy tips ... 4 Your new washer-dryer ...
General safety information Intended use This washer-dryer complies with the relevant safety regulations.. Hazard warnings Before using for the first time When washing and drying To protect the washer- dryer The washer-dryer is designed for: – domestic use only. – machine-washable fabrics in detergent solution and drying these fabrics.
Environmental protection/economy tips WEEE – Separate out the various waste materials of the packaging and take them to the nearest collection point. – Always fill the washer-dryer with the maximum load for the relevant programme. – Wash normally soiled laundry without a prewash. –...
Your new washer-dryer Description of the washer-dryer Door The washer-dryer can be used in 3 ways –> page 15: – washing only – drying only – successive washing and drying. The successive wash-dry programme automatically shifts from the wash cycle to the dry cycle without further intervention. Drying is achieved using the condensation principle.
Control panel Indicator lamp Indicates the settings that have been selected for: – Temperature: Ž - 90°C. – Spin speed: $ - 1400 rpm. – Options/signal. Indicator lamp Washing and drying options –> page 13 – °C (Temperature): individual adjustment of the washing temperature.
Before washing for the first time Preparing and sorting the laundry Sorting laundry for washing Sorting laundry according to the information on the care labels The washer-dryer was tested before leaving the factory. To remove any water that may be left over from the test, do not load any laundry the first time that you run a wash programme.
Page 8
Sorting laundry for drying Sorting laundry according to the information on the care labels Preparing laundry for washing Preparing laundry for drying Loading the laundry Only dry laundry that is labelled "suitable for tumble-drying" or which has the following care symbols: Care label Type of laundry Dry at normal temperature.
Detergents and Care Products Detergent drawer Descaler Detergents and care products The detergent drawer is divided into three compartments Compartment I : detergent for pre-wash. Compartment II : detergent for main wash, Compartment i : Liquid additives, such as starch or fabric softener. Additives are automatically dispensed during the final rinse cycle.
Page 10
Measuring washing powder Measuring liquid detergent Normally soiled laundry Set the programme. Do not select ! (Pre-wash) –> page 13. Add all the detergent, according to the manufacturer's instructions, to compartment II of the detergent drawer. Heavily soiled laundry Set the programme. Select ! (Pre-wash) –>...
Programmes Programme selector Washing programmes* *depends on the model The programme selector is used to set the washing and drying programmes. The time remaining until the end of the programme and the Beladungsmenge (Load) are shown on the display panel. Cottons Suitable for hard-wearing fabrics, heat-resistant fabrics made from cotton or linen.
Washing programmes* * depends on the model Drying programmes Special programmes Sensitive s For washing fabrics with increased hygiene requirements or those that will be used by allergy sufferers. The temperature remains constant during the washing process. More intensive rinsing with increased water level. For hard-wearing and easy-care fabrics made from cotton or linen.
Washing and drying options Temperature °C button Spin speed button B Rinse hold Unbalanced load detection system option button set button Options (symbols on the display panel) Pre-wash Intensive Easy-iron Water Plus R Flexi Time Signal 0 Finished in button The temperature can be adjusted individually for each programme.
Page 14
Drying button Drying options (symbols on the display panel) 0 Time-controlled The drying time can be set to between 2:40 and 0:00 by repeatedly pressing the drying 5 (Drying) button. P Iron-damp The residual moisture in the washing is increased. Enables easier ironing. e Cupboard-dry The laundry is dry and ready to put away.
Washing and drying Washing only Drying only Washing and drying Turn the programme selector to the desired programme, e.g. ic Cottons 60°C. – The display panel alternately shows 2 (Remaining time) and the recommended load in kg. The % symbol flashes. If necessary, adjust the temperature and the spin speed and select any options for your individualised programme, –>...
Page 16
End of the programme Rinse hold Childproof lock The washing and drying programmes are ended automatically. appears on the display panel. Turn the programme selector to Off. Remove the washing from the drum. Leave the door open to allow the inside of the washer-dryer to dry out. Turn off the tap (not necessary on models with Aqua-Stop).
Cleaning and care Safety information Housing and control panel Drum Detergent drawer Risk of electric shock You must disconnect the appliance from the mains first. Never clean the washer-dryer with a water jet. Risk of explosion. Never clean the washer-dryer with solvents. Risk of scalding Hot washing water must be cooled before Draining.
Drain pump Draining the water Cleaning the Drain pump Filter in the water supply hose Descaling the washer-dryer Set the programme selector to Off. Use a screwdriver to release the lock pins. Tip the kick panel and pull upwards to remove. Take the Drain hose out of the retainer.
What to do if... Fault code Other fault codes are only for use by the after-sales service. Make a note of the fault code to inform the after- sales service. Fault Programme does not start. The maximum spin speed cannot be set. The water is not Drained.
Page 20
Water is not flowing in. Intense vibrations during spinning. Washer-dryer fills with water and continuously Drains it away. No water can be seen in the drum. Water leaks from the bottom of the appliance. Foam escapes from detergent drawer. Several attempts to start spinning.
Page 21
Programme terminated unexpectedly. Spinning during drying Drying result not satisfactory. The fabric softener is not completely flushed in or too much water remains in the compartment i. The laundry is not dried. No display on the display panel. The door cannot be opened. $ (Rinse hold) has been selected. Emergency release If you cannot correct a fault yourself (switching on/off) or a repair is required: –...
After-sales service Before you call the after-sales service, please check whether you can cor- rect the fault yourself –> page 19. You will be charged if a technician is called out, even during the warranty period. You can find information about your nearest after-sales service here or in the After-sales service directory (depending on the model).
Installation instructions Safety information Included with the appliance The washer-dryer is very heavy. Take care when lifting it. Do not operate the washer-dryer if it has any visible damage. If you are in any doubt, please consult our after-sales service or your retailer. Do not install the washer-dryer outdoors or in areas exposed to frost.
Page 24
Removing the transport safety bolts Positioning and levelling Positioning Unscrew all four screws Remove all 4 transport safety bolts using the spanner completely and take the mains cable out of supplied. the retainers. – Before using the appliance for the first –...
Page 25
Levelling Hose and cable lengths Left-hand connection approx. 1350 min. max. approx. 1400 Dimensions Width x depth x height Weight Intense noise, vibrations and “wandering” may be the result of incorrect levelling. – All four appliance feet must stand firmly on the ground. –...
Water connection Water supply Water Drainage Drainage into a siphon To prevent leaks or water damage, you must observe the instructions in this section. If in doubt, have a technician connect the appliance. The water supply and Drain hoses can be routed to the left of right, depending on installation conditions.
Page 27
Electrical connection Fitting the door hinges to the washer-dryer The washer-dryer must only be connected to an alternating current supply via a properly installed earthed socket. If a residual current circuit breaker is used, only use a type which displays this symbol: ‚.
Table of programmes Observe the information on care labels, fabric type and load quantity. In order to select the most suitable programme for the laundry, observe the information on the labels that are attached to most items. Programmes* °C cold-30-40-60-75-90 Cottons cold-30-40-60 Cottons Eco...
Need help?
Do you have a question about the WKD28540GB Installation Instructions, Instructions for Use, Programme Table and is the answer not in the manual?
Questions and answers