Solving Problems With Plug-In Modules; Cd-Rom / Floppy Drive Problems - HP OmniBook 7150 User Manual

Solving Problems with Plug-In Modules

If your OmniBook plug-in module doesn't seem to work properly, find the symptom
below that matches your situation. Try the suggestions one at a time.
This section separates problems into the following categories:

CD-ROM / floppy drive problems.

LS-120 drive problems.
DVD drive problems.
Battery problems.
CD-ROM / Floppy Drive Problems
If the CD-ROM drive stops responding
Remove and reinsert the CD-ROM disk.
Reset the OmniBook.
Remove and reinsert the CD-ROM / floppy drive module.
If you cannot boot from a CD in the CD-ROM drive
Check that the CD is bootable.
Reset the OmniBook.
Remove and reinsert the CD-ROM / floppy drive module.
Run the BIOS Setup utility to make sure that the CD-ROM drive is the first boot
device. See the OmniBook Reference Guide for instructions on running the BIOS
Setup utility.
If the floppy drive doesn't work
Remove and reinsert the floppy disk.
Remove and reinsert the CD-ROM / floppy drive module.
Troubleshooting
1-21