Using Docking Products; To Install A Docking Tray; To Dock The Omnibook - HP OmniBook 7100 User Manual

Using Docking Products

To install a docking tray.

To dock the OmniBook.

To undock the OmniBook.
The OmniBook docking products provide external connections for the OmniBook
that you can leave in place whenever you remove the OmniBook from your desk.
Instead of disconnecting and reconnecting peripheral devices, you simply undock
and dock the OmniBook.
Refer to the User's Guide for OmniBook docking products for more information.
To install a docking tray
Your dock requires a tray that accommodates your specific OmniBook model. You
must ensure that this tray is installed prior to docking the OmniBook.
1. Select the tray labeled with the letter A.
2. Slide the rear of the tray into the dock as shown on the label on the dock.
3. Push down firmly on both sides of the tray until it snaps into place.
To remove a tray from the dock, pull the latch (near the center front of the dock)
towards you until the tray pops free.
To dock the OmniBook
37