System Board - HP Mini 1000 Maintenance And Service Manual

System board

NOTE: The system board spare part kit includes a processor and replacement thermal material.
Description
System board equipped with 1.6-GHz processor
Before removing the system board, follow these steps:
1. Shut down the device. If you are unsure whether the device is off or in Hibernation, turn the device
on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the device.
3. Disconnect the power from the device by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the device.
4. Remove the battery (see
5. Remove the following components:
a. Keyboard (see
b. Hard drive or solid-state drive (see
c. Top cover (see
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
●
WLAN module (see
●
RTC battery (see
●
Bluetooth module (see
●
Heat sink assembly (see
Remove the system board:
1. Disconnect the wireless antenna cables from the terminals on the WLAN module (see
module on page
Battery on page
Keyboard on page
Top cover on page
WLAN module on page
RTC battery on page
Bluetooth module on page
Heat sink assembly on page
43).
32).
35)
Mass storage devices on page
40)
43)
45)
46)
51)
Component replacement procedures
Spare part number
504592-001
37)
WLAN
47