Table of Contents
Advertisement
1. Extend the assembly cable if necessary.
It may cause fire.
2 . Open the cover panel.
3 . Remove the screw securing the connector cover.
4 . Pass the assembly cable through the rear of the indoor unit and connect the assembly cable to terminals.
(Refer to the picture below)
5 . Pass the other end of the cable through the 2.56inch(65mm) hole in the wall.
6 . Close the connector cover by tightening the screw carefully.
7 . Close the cover panel.
8 . Remove the terminal board cover on the side of the outdoor unit.
9. Connect the cables to the terminals as seen in the picture.
Indoor unit
Outdoor unit t
10. Connect the grounding conductor to the grounding terminals.
11. Close the terminal board cover by tightening the screw carefully.
installation.
(If they are loose, it could cause burn-out of the wires.)
Indoor unit
L1
L2
F1
L1 L2
F 1
L1
L2
Outdoor unit
English-43
F2
F 2
F 1
F 2
Advertisement
Table of Contents
