HP Compaq Presario,Presario V2600 Maintenance And Service Manual page 102

Removal and Replacement Procedures
5. Make note of which wireless antenna cable is attached to
which antenna clip on the Mini Card module before
disconnecting the cables, then disconnect the cables 1 from
the module.
6. Remove the two black Phillips PM2.0×5.0 screws 2 that
secure the Mini Card module to the system board. (The edge
of the module opposite the Mini Card socket rises away from
the computer).
7. Remove the Mini Card module 3 by pulling the module
away from the socket at an angle.
✎
Mini Card modules are designed with a notch 4 to prevent
incorrect installation into the Mini Card module socket.
Removing a Mini Card Module
Reverse the above procedure to install a Mini Card module.
5–16 Maintenance and Service Guide