Table of Contents
Advertisement
POWER LED
When the POWER LED is flashing other than
during power up or down of this unit, check the
message on the TV screen. If a message is not
displayed on the TV screen, determine the type of
the error by checking the way the POWER LED is
flashing.
Symbols indicate the following states:
Flash
No illumination
Repetition
(Flashes 6 times)
The remote control and this unit are using
different codes.
Turn on this unit by using [Í/I] on the main
unit, and check "Remote Control " which is
displayed on the screen when you press a
button on the remote control.
Press and hold [OK] and the displayed
number (" ") for at least 5 seconds.
(Flashes 4 times)
The unit fails to operate properly. Press [Í/I]
on the main unit for 3 seconds to switch the
unit to standby, then switch back on.
(Flashes)
The copyright protected disc cannot be
played back.
One of the devices connected to this unit (TV,
amplifier, etc.) does not support copyright
protection.
Temperature of this unit is hot and the unit
switches to standby for safety reasons.
Wait for about 30 minutes.
Install or place this unit with good ventilation.
A firmware update is in progress.
(Flashes 3 times)
The disc in use cannot be played back since
the copyright information is invalid.
A firmware update using a USB device is
complete.
Reference
- 33 -
Advertisement
Table of Contents
