Panasonic KX-NCP0158 Quick Installation Manual page 38

Dect 6.0 8-channel ip cell station unit
Hide thumbs Also See for KX-NCP0158:
Table of Contents

Advertisement

7 Connecting IP Cell Stations
10.
Assign the IP addressing information automatically
through a DHCP server or enter it manually.
Note
It is not necessary to configure the Primary PBX
IP Address setting regardless of whether or not
you are using a DHCP server, because it is
detected automatically.
When using a DHCP server:
a.
Select Enable for the DHCP Client setting.
b.
Click Next.
A dialog box will appear.
When not using a DHCP server:
a.
Select Disable for the DHCP Client setting.
b.
In the IP Address box, type the IP address of the
IP-CS.
*1
c.
In the Subnet Mask box, type the subnet mask
address of the network.
d.
In the Default Gateway box, type the IP address
of the default gateway.
e.
Click Next.
A dialog box will appear.
11.
Click Yes.
If the assignment is successful, the dialog box will show
"Setup Success!".
12.
Click Next Device to assign the IP addressing
information for other IP-CSs, or click Main Screen to
return to the main screen.
13.
Click Exit.
14.
Disconnect the IP-CS from the AC adaptor, PoE hub,
or PoE adaptor to stop supplying electricity.
15.
Return the Fixed IP Setting Mode switch of the IP-CS
to the OFF position.
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*1
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
Note
For information on other parameters, refer to "D Information about IP Terminal Maintenance Console".
Connecting an IP-CS to a Switching Hub
When connecting an IP-CS to the LAN, connect it to a switching hub.
Note
Use an Ethernet straight cable with an RJ45 connector to connect the IP-CS to a switching hub. The
cable should be a 10BASE-T/100BASE-TX CAT 5 (Category 5) or higher cable, and the diameter of
the cable must be 6.5 mm or less.
When using the VLAN feature on the network, make sure that the switching hub to be connected is
IEEE 802.1Q compliant and is configured for VLANs. In addition, the port of a switching hub that the
38
Quick Installation Guide
*2
*1
Document Version 2009-06

Advertisement

Table of Contents
loading

Table of Contents