Installation - Panasonic 932CY-BT100U Manual

Installation

Warning
¡ This installation information is designed for professional
installers with knowledge of automobile electrical safety sys-
tems and is not intended for non-technical, do-it-yourself indi-
viduals. It does not contain instructions on the electrical installa-
tion and avoidance of potential harm to air bag, anti-theft and
ABS braking or other systems necessary to install this product.
Any attempt to install this product in a motor vehicle by anyone
other than a professional installer could cause damage to the
electrical safety systems and could result in serious personal
injury or death.
¡ If your car is equipped with air bag and/or anti-theft systems,
specific procedures may be required for connection and discon-
nection of the battery to install this product. Before attempting
installation of this electronic component against the manufac-
turer's recommendation, you must contact your car dealer or
manufacturer to determine the required procedure and strictly
follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE
UNINTENDED DEPLOYMENT OF AIR BAGS OR ACTIVATION OF
THE ANTI-THEFT SYSTEM RESULTING IN DAMAGE TO THE VEHI-
CLE AND PERSONAL INJURY OR DEATH.
22
Installation Hardware
Main Unit
CY-BT100U CY-BT100U
q
Q'ty: 1
Switch Unit
w
(2 m)
Q'ty: 1
Microphone with Bracket
e
(5 m)
Q'ty: 1
System-up Connecting cable
r (3 m)
Q'ty: 1
Double-sided Tape
t (12 x 55 mm)
Q'ty: 2
Double-sided Tape
(15 x 30 mm)
y
Q'ty: 1
Cable Clamp
u
Q'ty: 5
Caution
¡ Make sure that wiring is completed before installation.
¡ Do not install the product where it is exposed to strong
vibrations or is unstable. Avoid slanted or strongly curved
surfaces for installation. If the installation is not stable,
the unit may fall down while driving and this can lead to
an accident or injury.
1
Remove the cable from the battery negative
terminal.
2
Connect all cables of the Hands-Free Kit fea-
turing Bluetooth ® technology.
3
Secure the Main unit q, Switch Unit w and
Microphone with Bracket e.
q Attach the Main unit q and the Switch Unit w with the
double-sided tape t y.
Switch Unit w Main Unit q
Peel off the back papers
Peel off the back papers
w Secure the microphone with bracket e.
e Secure all connection cables with Cable Clamp u.
Attach the Microphone with
Bracket e by clipping on the
sun visor etc.
Fix the cable with the
Cable Clamp u. Sun visor
4
Reconnect the Battery Cable.
23