Table of Contents
Advertisement
Cleaning and maintenance
en
Clean the drainage hose and siphon
3.
connecting piece.
Reattach the drainage hose and
4.
secure the connection using the
hose clamp.
Filter in the water supply
blocked
For this, first reduce the water pressure
in the supply hose:
Turn off the water tap.
1.
Select any programme (except
2.
Rinse O // 0 Spin/Drain [ ).
Press Start/Reload A . Allow the
3.
programme to run for approximately
40 seconds.
Set the programme selector to off
4.
position. Disconnect the mains plug.
Clean the filter on the water tap:
5.
Remove the hose from the water tap.
Clean the filter with a small brush.
For standard and Aqua-Secure
6.
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance,
Remove the filter using pliers and
clean the filter.
26
Connect the hose and check for
7.
leaks.
Advertisement
Table of Contents
