Select Programme/Switch On The Appliance; Change The Programme Default Settings; Select Additional Programme; Settings - Bosch WAK24268IN Instruction Manual And Installation Instructions

Operating the appliance
en
Select programme/switch on
the appliance
If you have activated the
Note:
childproof lock, you must first deactivate
it before you can set a programme.
Use the programme selector to select
the required programme. Can be turned
in either direction.
The machine is switched on.
The display panel shows the following
information consecutively for the
selected programme:
The programme duration,
■
The preset temperature,
■
The preset spin speed and
■
The maximum load.
■
Change the programme
default settings
You can use the default settings or
change them.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
The settings are activated without
needing to be confirmed.
They are not saved when the appliance
is switched off.
Programme default settings
~ Page 16
Overview of programmes ~ Page 13

Select additional programme

settings

By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the
programme progress.
18
The indicator lamp for the button lights
up if a setting is active.
The settings are not saved when the
appliance is switched off.
Additional settings ~ Page 17
Overview of programmes ~ Page 13

Placing laundry into the drum

:
Warning
Danger of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the washing machine.
Hand-rinse items of laundry thoroughly
beforehand.
Notes
Mix items of laundry of varying sizes.
■
Laundry items of different sizes
distribute themselves better during
the spin cycle. Individual items of
laundry may lead to imbalances.
Observe the specified maximum
■
load. Overfilling has a negative
impact on the washing result and
promotes creasing.
Place presorted items of laundry
1.
unfolded in the washing drum.
Make sure that no items of laundry
2.
are trapped between the washing
machine door and the rubber seal,
and close the door.
The Start/Reload A button indicator
lamp flashes and the programme
settings continue to be displayed on the
display panel one after another. It is
possible to change the settings.