Sharp DV-RW360H Operation Manual page 92

Symptom
Timer recording is not completed
or did not start from the
beginning.
There is no sound.
Timer recording is not possible.
The remote control does not
function.
The unit does not operate
correctly.
There is no picture.
Picture noise appears.
Sound is noisy.
The unit does not play back the
disc.
There is no sound.
Playback image freezes for a
moment.
The unit does not play back the
disc from the beginning.
The unit starts playing back the
disc automatically.
92 EN
Downloaded from: http://www.usersmanualguide.com/
Others
Troubleshooting (cont'd)
VCR / DVD
• The timer setting overlapped with another setting that has priority.
(See page 34.)
• There was not enough disc or tape space.
• The disc is dirty or flawed.
• Check if all cables are connected securely.
• Check if a connecting cable is damaged.
• Check the connections to the amplifier input.
• Check if the input source setting on the amplifier is correct.
• Check if the unit is in Pause mode or in Slow-motion Playback mode.
• Check if the unit is in Fast Forward or Fast Reverse mode.
• Make sure icon appears on the front panel display of this unit. If not, press
[T-SET].
• Batteries are exhausted.
• There are obstacles between the remote control and the unit.
• The remote control is too far from the unit.
• There are no batteries in the remote control.
• The unit is not turned on.
• The remote control is not pointed at the remote sensor on the unit.
• Check if the Child Lock is activated. (See page 10.)
• Press [VCR] or [DVD], whichever you need. Then, try again.
• If static electricity or anything else causes the unit to operate abnormally,
unplug the mains cable and plug it in again.
DVD
• If the Setup menu display appears, press [SETUP] or [RETURN
the display.
• The disc is dirty or flawed.
• If the unit is connected to your TV via a VCR, or if it is connected to a
combination TV / VIDEO player, the copy-protection signal applied to some
DVD programmes could affect picture quality. If you still experience this
problem even when you connect the unit directly to your TV, try connecting
the unit to your TV's S-VIDEO input.
• The disc is dirty or flawed.
• No disc is inserted.
• A blank disc is inserted.
• The disc is upside down. Insert the disc with the labelled side facing up.
• The disc is not correctly inserted.
• The unit cannot play back certain discs (such as a CD-ROM). (See page 42.)
• The region codes on the DVD-Video and the unit are not matched. (See page 42.)
• Moisture has condensed inside the unit. Remove the disc and leave the unit
turned on for about two hours until the moisture evaporates. (See page 3.)
• The unit cannot play back the disc if it was recorded on another recorder and
not finalised.
• If the audio signal is not output from the DIGITAL AUDIO OUT (COAXIAL)
jack, check the Audio setting. (See pages 81-83.)
• During the playback of a two layered disc, the picture may freeze for a
moment while playback switches from the first to the second layer. This is
not a malfunction.
• Resume playback is activated. (See page 49.) Press [STOP C] twice.
• You have inserted a disc whose Title menu or DVD menu automatically
appears on the TV screen when it is first inserted.
• The DVD-Video features an auto playback function.
Remedy
] to turn off