General Installation - Moffat CR5L Operating & Service Manual

2: General Installation

Before installation please read the following points:
• When placing the oven into position ensure there is adequate access.
• Move into position and adjust feet setting the oven level.
• The oven can be place either on a table top or on Moffat's support stands
• Table tops must be strog enought to hold the weight of the oven
• Before installing, it is recommended that the area is cleaned.
This equipment is designed to be operated by suitably qualified persons.
It is the responsibility of the Supervisor or equivalent to instruct users,
provide suitable P.P.E., show the mains isolating switch location, and
inform users that parts may become hot, causing injury if touched.
1. Remove all packaging & plastic coatings from the appliance.
2. Check for any damage.
3. Assemble all parts, shelves and shelf hangers etc.
4. Ensure all switches are in the OFF position.
5. Connect the mains input plug to the socket outlet.
6. Turn on and check the unit is functioning correctly.
Installation options
The oven top and special stands are fitted with location supports channels.
Simply position one oven on top of the other making sure the feet are located into the support
channels, Maximum limits for stacking are shown in the diagram below.
5