Getting Started; Installing Filters; Using The Appliance; Understanding The Air Quality Light - Philips 2000 Series User Manual

3 Getting started

Installing filters

Note
• Make sure the air purifier is unplugged
from the electrical outlet before
installing the filters.
• Make sure the side of the filter with the
tag is pointing towards you.
1
Remove all packaging materials of
the air purification filters (fig. c).
2
Pull the bottom part of the front
panel to remove it from the
appliance (fig. d).
3
Press the two clips down and pull
the pre-filter towards you (fig. e).
4
Put the unpacked air purification
filters back into the appliance
(fig. f).
5
Attach the pre-filter back into the
appliance (fig. g).
Note
• Make sure that the side with the two
clips is pointing towards you, and that
all hooks of the pre-filter are properly
attached to the purifier.
6
Reattach the front panel by pressig
the top part of the panel onto the
top of the air purifier (1). Then, gently
push the panel against the body of
the air purifier (2) (fig. h).
7
Wash your hands thoroughly after
installing filters.
6 EN
4 Using the
appliance
Understanding the air
quality light
PM2.5 Air quality
level light color
≤12
Blue
13-35 Blue-Purple
36-55 Purple-Red
>55 Red
The air quality light automatically goes
on when the air purifier is switched on,
and lights up all colors in sequence.
After approximately 30 seconds, the
air quality sensors select the color that
corresponds to the surrounding air
quality of airborne particles.

Switching on and off

1
Put the plug of the appliance in the
wall outlet.
2
Touch to switch on the appliance
(fig. i).
» The appliance beeps.
» The appliance operates under
the Pollution mode by default.
» After measuring the air quality
for a short time, the air quality
sensor automatically selects the
color of the air quality light.
Air quality
level
Good
Fair
Poor
Very poor